Lokset® Spin to Stall

LOKSET® SPIN TO STALL.
Lokset capsules are filled with a reinforced thixotropic polyester resin in one compartment and a catalysed mastic filler in the other, separated by a physical barrier. The rotation of the bolt during installation ruptures the capsule, shreds the skin and mixes the two components causing a chemical reaction and transforming the resin mastic into a solid anchor.
The capsule is available in 50:50 ratio of fast: slow speeds
.jpg)
Advantages
- 1 FAST SETTING, EASY TO USE
- 2 SHORT INSTALLATION TIME
- 3 QUICK, HIGH LOAD TRANSFER
Features
Rapid insertion, easy and quick to use
Shorter installation times with no hold time required
Easy to install, requiring no specialty injection equipment
Resistant to anchoring failure caused by blasting or vibration
Rapid anchoring of the bolt to the surrounding strata
High load transfers achievable almost immediately
Full column bonded bolts strongly resist the horizontal and lateral strata movement associated with convergence
Provides strength and rigidity to prevent sag
Acts as a reinforcement that clamps the individual strata layers into a single high strength beam
Effectively seals wet, dripping holes and in most cases eliminates deterioration of the hole and surrounding strata
Unaffected by sea or fresh water, mild acids or mild alkaline solutions
Immediately fixes rock bolts / anchors
Protects bolts from corrosion, can be used in wet/underwater condition
Configurations
CAPSULE SPEED | CAPSULE CODE | RATIO | SPIN TIME* |
---|---|---|---|
FAST/ SLOW | FS | 50:50 | 12-15 s |
Typical insertion properties at 25°C * Approximate spin time in seconds
Product Options
Lokset Spin to Stall - SKU NF0000460, 1,000mm L x 25mm D, 4 month shelf life
Lokset Spin to Stall - SKU NF0000461, 1,200mm L x 25mm D, 4 month shelf life
Lokset Spin to Stall - SKU NF0000462, 1,400mm L x 25mm D, 4 month shelf life
Industry sectors
-
Coal Mining
-
Hard Rock Mining
Common use
- Anchoring
- Ground control
Available Regions
- Asia
- Australia and New Zealand (ANZ)