Ekopur LS/G is a polyurethane sprayed membrane used for protection, insulation and sealing of sidewalls and ceilings, insulation of dams and roof support components. Ekopur LS/G is especially recommended as a base, ground layer before spraying other systems.
This PU system is obtained after mixing component A (poliols and additives) and component B (polymeric MDI isocyanate with additives) in a volume ratio of 1:1. Its properties allow to use the systems under various geological and mining conditions.
Excellent adhesion to various rock substrates
Very good hydro- and gas-insulation
It has the (PZH) Hygienic Assessment certificate
It reaches a desired strength in a short time
It does not increase the endogenous fire risk
It can react in contact with salt rock or in presence of salt
The components are packed into barrels/canisters with a capacity of 20 or 30 liters.
Minobond Pumpable Grouts
We offer two different products within this category, that vary in setting speeds and application area.
Minobond AM is an anchoring mortar used for the grouting of steel parts in horizontal and vertical concrete surfaces and the filling of scratches, cracks, joints and deficiencies of concrete.
Minobond APS is a single component highly fluid rapid setting grout, designed especially for APS sewer manhole repair, whilst it is also used for filling backfill voids.
When mixed with water, the material sets within minutes. It creates a coating with instant resistance to pulling off and delamination caused by active leaks of water. It is particularly recommended for areas with high moisture content or highly watered.