Capcem™ Plug a mortar formulated for the rapid sealing of water leaks from fissures and cracks, where slower setting conventional mortars would be washed away and where fast setting resin mortars will not bond on wet surfaces. It is suitable for most rock types, concrete and brick.
It is supplied as a dry powder needing only the addition of water to produce an ultra-rapid set plugging mortar. This mortar sets rapidly to form a hard, durable mortar with an ultimate compressive strength of 10 MPa when mixed as advised.
Rapid set stops water leaks quickly
Permanent sealing effect
Only water needs to be added
Non-toxic, non-combustible and non-corrosive mortar
Mixed in the proportion 3 parts Capcem™ Plug powder by volume to 1 part water
Due to the rapid set, only small quantities should be mixed each time
The mortar cures best in humid conditions where dry-out can be avoided
Capcem™ Plug 1 - 1 minute, Pack Size: 10 kg
Capcem™ Plug 3 - 3 minutes, Pack Size: 10 kg
Support where you need it
We provide you with solutions for both active and passive methods of rock support wherever you are.
Our products range from various steel and Glass Fibre Reinforced Polymer (GFRP) bolts to steel arches, meshes and shotcretes.
Our offering can help you with:
Roof and ground control
Permanent and temporary rock bolting
[DSC01634 no logo.png insert photo]
The complete solution.
Bolts alone may not be enough.
Many applications require additional components to ensure the desired results.
We provide steel and GFRP accessories that work in combination with our products for you to achieve the best outcomes. From drill bits, couplings, meshes to plates and nuts and trusses. Our portfolio works to provide you with the right solutions wherever you are.
The Lokset system consists of an easily handled cartridge, containing a highly reinforced polyester resin component, together with its catalyst, in accurately measured quantities.
Reaction takes place when the roof or rock bolt is rotated through the cartridge, mixing the components and initiating the curing action. The chemical nature of the Lokset cartridge allows the contents to be easily mixed, yet minimises resin run-out after mixing is complete.
The setting time of the resin components can be controlled. A combination of fast and slow-setting cartridges makes possible the simultaneous operation of anchoring, grouting and tensioning a rock bolt. The simplicity of this method of anchoring/grouting eliminates the need for cumbersome injection equipment.
The cartridges are designed for rapid insertion into a range of borehole sizes, where they may be readily pushed to the extremity at any angle above or below the horizon